JEEP JK LONGARM UPGRADE Thank you for choosing Rough Country for your suspension needs. Rough Country recommends a certified technician instal
13. Place a piece of cardboard or thin sheet metal between the fuel tank and inside of the frame, this will help keep sparks off the fuel tank while
22. Using three of the short flag nuts out of 1787box4, insert the flag nut through the 1 1/4” holes and hand tighten the 7/16” x 1.5” long bolt, was
36. Locate the 4 sway bar link sleeves. Insert the sleeves into the sway bar link bushings. Using the supplied .500-16 x 2.75” bolts, washers and nut
Thank you for purchasing a Rough Country Suspension System. 45. Remove the e-brake cable bracket from the body using a 10mm wrench as shown in Photo
PHOTO 1 PHOTO 2 POST INSTALLATION IMPORTANT NOTE : The draglink must be adjusted to the center steering wheel BEFORE the vehicle is driven. Failur
JEEP JK EXHAUST LOOP RELOCATION PIPE Thank you for choosing Rough Country for your suspension needs. This exhaust loop relocation pipe kit is intend
3. Slide the new exhaust loop over the factory cut exhaust and hand tighten. See Photo 3. 4. Using the supplied 7/16” x 2.5’ bolts and flange nuts
N • Crossmember (A) • Crossmember brace driver (B) • Crossmember brace passenger (C) • Front bumpstop ext. (D) • Rear bumpstop ext. (E) • Driver
1. Place vehicle in park and chock the rear wheels. Using a 21mm socket, remove bolt securing the front track bar to the frame. Retain stock hardwar
12. Next the upper and lower factory control arm pocket have to be removed to make clearance for the longer arms. This will be done using a plasma cu
21. Support the transmission with a jack stand and remove the three factory bolts from the bottom of the crossmember that holds the transmissions wit
31. Adjust the supplied front lower control arms to the length of 34 3/4” center to center. Install the flex joint end of the lower control arm to th
40. Loosen the stock brake line from the metal line on the frame rail shown using a 12 mm line wrench. A catch pan will be needed to catch the brake
56. Using two of the crossmember flag nuts and factory skid plate bolts attach the skid plate to the crossmember as shown in Photo 28 & 29. Tight
REAR INSTALLATION INSTRUCTIONS 1. Chock front wheels. Jack up the rear of the vehicle and support the vehicle with jack stands, so that the rear whee
Kommentare zu diesen Handbüchern