Rough-country 781 Bedienungsanleitung PDF herunterladen (Seite 16)

3. Slide the new exhaust loop over the factory cut exhaust and hand tighten. See Photo 3.

4. Using the supplied 7/16” x 2.5’ bolts and flange nuts attach the exhaust loop to the factory flange. Make sure the ex-

haust pipes are in align with each other. Tighten with a 11/16 and 5/8 wrench. See Photo 4. Next tighten the upper

clamp using a 15mm wrench.

5. If your jeep is already equipped with aftermarket exhaust extensions use the supplied 7/16” x 3.5” long bolts instead

of the shorter 2.5” bolts. This will allow you to insert the extension between the exhaust flanges. See Photo 5.

POST INSTALLATION INSTRUCTIONS

• All hardware must be tightened at 500 miles after installed and then checked periodically to ensure all fasteners are

tight.

PHOTO 3

PHOTO 4

PHOTO 5

1 2 ... 11 12 13 14 15 16

Keine Kommentare

Rough-country 781 Bedienungsanleitung Seite 16