Rough-country 781 Bedienungsanleitung PDF herunterladen (Seite 3)

1. Place vehicle in park and chock the rear wheels. Using a 21mm socket, remove bolt securing the front track bar to

the frame. Retain stock hardware. See Photo 1. Raise the front of the vehicle with a jack and secure a jack stand

beneath each frame rail behind the front control arms. Ease the frame down onto the stands. Support the axle with a

floor jack.

2. Remove the front tires/wheels

using a 19mm deep well socket.

3. Using a 18mm socket and wrench remove the bottom sway bar bolts. Using a 21mm socket and 21mm wrench, re-

move the top of the sway bar link. See Photo 2.

4. Remove the front factory skid plate with a 19mm socket.

5. Remove the lower shock bolt using a 18mm socket and wrench. Using a 14mm wrench unbolt the top of the shock

and remove. See Photo 3. Retain stock hardware.

6. On some models it will be necessary to remove the brake line bracket from the frame to allow the coils to be re-

moved. Using a 10MM socket, remove the brake line bracket from the stock location.

7. Lower the axle with the floor jack to allow room for the coils to be removed. Remove stock coil springs. Retain upper

coil isolators.

8. Remove the bolts securing the upper control arms to the axle and frame using a 18mm wrench/socket. It may be

necessary to cut out the passenger side upper bolt as shown in Photo 4 to remove the control arm. A new bolt is

supplied in the hardware bag to replace this factory bolt. Retain factory axle end hardware.

9. Using a 21mm wrench, remove the bolts that secure the lower controls to the axle and frame then remove the con-

trol arm. Retain factory axle end hardware.

PHOTO 3

PHOTO 1

PHOTO 2

PHOTO 4

1 2 3 4 5 6 7 8 ... 15 16

Keine Kommentare

Rough-country 781 Bedienungsanleitung Seite 3