Rough-country 781 Bedienungsanleitung PDF herunterladen (Seite 11)

22. Using three of the short flag nuts out of 1787box4, insert the flag nut through the 1 1/4” holes and hand tighten the

7/16” x 1.5” long bolt, washer, and lock washer. See Photo 42

23. Next using the longer flag nut out of 1787box4, insert the flag nut through the back 1 1/4” hole and align the nut with

the bottom rear hole in the control arm bracket as shown in Photo 43. Insert the 7/16” x 1.5” long bolt, washer, and

lock washer and tighten with a 5/8 socket. Make sure when you tighten the bolts for the flag nuts you are holding the

stem of the flag nut with vise grips.

24. Locate the supplied passenger rear lower control arms from box 1787box4 and adjust the length to 41 1/8” center to

center of each end.

25. Insert the flex joint end of the control arm into the new frame bracket using the supplied 9/16” x 4” long bolt, washer,

and lock nut from bag 1787bag3. Tighten with a 21mm and 22 mm wrench shown in Photo 44

26. Insert the rubber bushing end of the control arm into the axle mount, using stock hardware and tighten with a 21mm.

27. Adjust the upper control arm to length to 12 1/4” and insert the rubber bushing end to the bracket on the lower con-

trol arm using the 10mm x 80mm long bolt, washer, and locknut. Hand tighten.

28. Next insert the flex joint end of the upper control arm into the factory axle bracket using stock hardware as shown in

Photo 45. Tighten with a 21mm wrench as shown in Photo 46. Now tighten the rubber bushing end with a 5/8” and

11/16” wrench. See Photo 47

29. Repeat steps 17-28 on the driver side.

PHOTO 46

PHOTO 45

PHOTO 44

PHOTO 42

PHOTO 43

PHOTO 47

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Rough-country 781 Bedienungsanleitung Seite 11