Rough-country 781 Bedienungsanleitung PDF herunterladen (Seite 5)

21. Support the transmission with a jack stand and remove the three factory bolts from the bottom of the crossmember

that holds the transmissions with a 15mm socket. Next remove the two factory bolts that connect the skid plate to the

crossmember using 15mm socket. Retain factory bolts.

22. Remove four factory bolts holding the crossmember with a 18mm socket and wrench, then remove the crossmeber.

Retain factory hardware.

23. Next install the supplied new crossmember as shown in Photo 11 with the control arm pockets facing forward. Insert

the four factory bolts from the back side of the crossmember with the thread side forward. Do not tighten at this time.

24. Using a transfer punch or a old bolt knock the factory thread insert out of the frame where the factory skid plate

bolted to the bottom side of the passenger side frame rail. See Photo 12

25. Slide the passenger side crossmember support bracket over the factory crossmember bolts as shown in Photo 13.

Hand tighten with the factory nuts.

26. Next insert the crossmember brace threaded tab through the frame hole in Photo 14. Align the holes in the tab and

bracket, using the supplied 7/16” x 1.5” long bolts, washers, and lock washers out of 1787bag1. See Photo 15

Tighten with a 5/8” socket.

27. Finally tighten the crossmember bolts with a 18mm socket and wrench.

28. Repeat steps 24-27 on the driver side.

29. Remove the jack stand holding the transmission and let

the transmission studs drop into the crossmember. Using

a 15mm socket insert and tighten the three nuts holding

the transmission to the crossmember.

30. Insert two of the crossmember flag nuts into the slotted

holes in the crossmember and align the flag nuts with the

two factory holes in the skid plate. Tighten factory bolts

with a 15mm socket.

PHOTO 11

PHOTO 12

PHOTO 13

PHOTO 14

PHOTO 15

1 2 3 4 5 6 7 8 9 10 ... 15 16

Keine Kommentare

Rough-country 781 Bedienungsanleitung Seite 5