Rough-country 781 Bedienungsanleitung PDF herunterladen (Seite 10)

13. Place a piece of cardboard or thin sheet metal between the fuel tank and inside of the frame, this will help keep

sparks off the fuel tank while cutting the inside of the lower control arm pocket.

14. Follow along the bottom side of the frame cutting through the control arm pocket. See Photo 36.

15. Using a hand grinder clean up any sharp burrs or jagged edges left from cutting off the control arm pocket. Paint the

frame with a durable spray paint to prevent rusting. See Photo 37.

16. Repeat steps 12, 14, and 15 on the driver side control arm pocket.

17. Slide the passenger rear control arm mounting bracket onto the frame and measure 3 5/8” from the slot in the frame

to the edge of the supplied bracket. Use a block of wood and a jack to hold the bracket to the frame while drilling.

See Photo 38

18. Using the bracket as a pattern, drill six holes in the frame with a 15/32” drill bit as shown in Photo 39.

19. Using a 1 1/4” hole saw and the bracket as a template, cut two holes for flag nut access as shown in Photo 40.

20. Insert the threaded tab through the back 1 1/4” hole as shown in Photo 41 and push the tab forward until it aligns

with the front and middle hole on the bottom of the control arm bracket.

21. Using the 7/16” x 1.5” bolts, washers, and lock washers out of 1787bag4 start two of the bolts into the threaded tab.

PHOTO 36

PHOTO 37

PHOTO 38

PHOTO 39

PHOTO 40 PHOTO 41

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Rough-country 781 Bedienungsanleitung Seite 10