Rough-country 328S Bedienungsanleitung

Thank you for choosing Rough Country for all your suspension needs. Rough Country recommends a certified technician install this system. In addition

39. Install the spacer on strut using stock hardware using 15mm wrench. See Photo 37. 40. Install strut onto truck using 14mm wrench to tighten upper

45. Notch a section of the stock mount to remove the brake line as shown in Photo 43 and remove line from housing. Straighten bends in hard metal line

51. Slide the axle in the bearing assembly and install the knuckle on the upper ball joint using a 21mm and 10mm wrench. See Photo 49. 52. Tighten the

1. Remove wheels using a 22mm socket. 2. Remove ABS clip from axle. See Photo 1. 3. Remove the brake line as shown in Photo 2 using 13mm. 4. Remo

8. Remove upper track bar bolt using 21mm wrench. See Photo 7. 9. Remove the vent hose from axle. 10. Remove coil springs. See Photo 8. 11. Install

15. Install bushing a sleeves into shocks. Install shock onto truck using stock hardware with new flag nut for top bolt. See Photo 18. 2.2 Shock

21. Install track bar into bracket with stock bolt. You may have to do this with truck on the ground. Tighten upper bolt using 22mm wrench and lower w

CUTTING TEMPLATE

CUTTING TEMPLATE

KIT CONTENTS 1326Box1 Containing: 1-Fr Cross-member (A) 1-Rr Cross-member (B) 1326Box2 Containing: 1-Dr Fr Diff Brkt (C) 1-Dr Rr Diff Brkt (D)

A B C E D F G H I L L J K M M N N O O P P Q Q KIT CONTENTS

1. Chock rear wheels of the vehicle and raise the front of the vehicle using a floor jack. 2. Support the vehicle with jack stands. 3. Remove wheel

9. Remove lower strut mount using 21mm and 24 mm wrench. See Photo 7. 10. Remove sway-bar link from sway-bar using 16mm wrench. See Photo 8. 11. Rem

16. Remove the two upper diff bolts from the motor mount / diff mount using 18mm socket. These bolt can be very hard to access. Also the diff mount ma

21. Align the supplied template with the lower holes. Tape cut out to driver side lower control arm rear pocket. 22. Cut at the line on the cut out.

26. Install passenger side diff bracket using stock hardware in upper location if motor mount is threaded . If not use sup-plied 12mm x 65mm bolts for

33. Install lower control arm using stock cam bolts. See Photo 31. 34. Install skid plate using supplied 3/8” X 1” bolts and 3/8” washers on the fro