Rough-country 1079 Bedienungsanleitung PDF herunterladen

XJ FRONT ADJ TRACK BAR KIT FOR 4”- 6” LIFT

92107900

Thank you for choosing Rough Country for your Jeep off road needs.

Please read all the instructions before beginning the installation.

PRODUCT USE INFORMATION

We will be happy to answer any questions regarding our products by calling us @ 800-222-7023. Rough Country will

not be responsible for any product that is altered. This kit is for use with vehicles lifted 4-6” of lift.

KIT CONTENTS

1-TRACK ROD BRACKET

1-ADJ TRACK ROD BODY & END

TOOLS NEEDED

18mm Socket / Wrench

19mm Socket / Wrench

24mm Socket / Wrench

1-POLY BAG CONTAINING:

2-Bushings

1-7/16” Sleeve

1-Heim End

2-Heim Spacers

2-7/16” X 2 3/4” Bolt

4-7/16” Flat Washers

2-7/16” Lock Nut

1-3/4” Jam Nut

INSTALLATION INSTRUCTIONS

1. Remove the track rod from the axle using a 15mm wrench /socket.

2. Remove the cotter pin from the track rod end on the frame and remove the nut using a 18mm socket (frame).

3. Remove the stock track rod bracket from the drivers side of the vehicle by removing the two side nuts on the frame

using a 18mm socket and the two lower bolts shown in Photo 1 on the bottom of the frame rail using a 15mm

wrench / socket. Retain the stock hardware for reuse.

4. Place the new track rod bracket in place on the studs on the side of the frame rail and tighten using a 18mm socket.

See Photo 2.

PHOTO 1

PHOTO 2

1 2

Seite 1

XJ FRONT ADJ TRACK BAR KIT FOR 4”- 6” LIFT 92107900 Thank you for choosing Rough Country for your Jeep off road needs. Please read all the instruct

Seite 2

POST INSTALLATION 1. Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile, fixed and heat

Keine Kommentare

Rough-country 1079 Bedienungsanleitung