2014 GM 4WD 1500 P/U 1 1/4” Body Lift Thank you for choosing Rough Country for all your suspension needs. Rough Country recommends a certified techni
11. Install new bumper brackets using stock hardware and a 40 torx to tighten. See Photo 12. 12. Reassemble rear bumper 13. Remove the body puck from
Kit Picture Thank you for choosing Rough Country.
1. Disconnect battery using a10mm socket 2. Using a screwdriver disconnect the air filter inlet hose from air box. See Photo 1. Lock the steering wh
7. Remove the side bumper support bracket using a 15mm socket . See Photo 7. 8. Unplug the fog lights and wiring harness from bumper. See Photo 8. 9
13. The other ground wire is on passenger side body mount behind the tire. See Photo 13. 14. Remove the O2 sensor wire clip from frame just above pass
18. Once the bushing is out knock the two studs out using a hammer and vise. See Photo 19. Replace the two stud with the supplied 3/8” x 2.25” bolts,
22. On the front frame horns measure the tow hook mounting hole on the side with only one hole 1 1/2” back and 1 3/16” up from bottom of frame. See Ph
25. On the inside of the front bumper where the tow hooks holes are measure 1/4 down on the inner bumper bracket and cut even with the sides of the ho
1. Loosen the 8 bolts holding the bed on using a 18mm socket. See Photo 1. Remove the six rear bolts on bed leav-ing the front bolts near cab in but
5. Using a torx 15 to remove lower bumper screws from the plastic bumper cover. See Photo 6. 6. Using a 7mm socket remove the screws from the inside
Kommentare zu diesen Handbüchern