Rough-country 1062 Bedienungsanleitung PDF herunterladen (Seite 3)

12. Place the winch plate assembly in between the frame rails of the Jeep and align holes in the frame. In this step it

does help to have someone hold the winch plate steady to allow the bolts to be inserted. Helpful Hint: Two bolts-one

on each side can be inserted in the front of the plate to temporarily hold the plate in position on the frame.

13. Install the supplied 1/2” x 1 1/2” bolt through the winch plate and through the frame as shown and secure with the

supplied flag nut. Tighten using a 3/4” wrench. See Photo 7 & 8.

14. If installing the optional d-ring mount at this time, place the mount on the plate and install the supplied button head

bolts and lock nuts on the front of the bumper and tighten using a 8mm allen wrench & 3/4” wrench. See Photo 9.

15. Install d-rings if mounts installed.

16. Route winch power / ground cables away from moving or sharp edges and install to battery.

17. Photo 10 shows winch installed.

18. If the 1062 kit was purchased

’ Remove the fog lights from the factory bumper and install in the Light Mount caps with

the supplied 10x24 nuts in the 1062 kit. Tighten hardware.

19. Reroute the wiring hardness and reinstall on the fog lights. NOTE: It may be necessary to extend the wiring if the

wiring hardness is too short to reinstall on the fog lights. In that case longer wires may be added in to extend the har-

ness. Be sure to weather proof the connection when complete.

Photo 7

Photo 8

Photo 9 Photo 10

INSTALL 1/2” x 1 1/2” BOLTS INSTALL FLAG NUTS FOR 1/2” X 1 1/2” BOLTS

INSTALL BUTTON HEAD BOLTS / NUTS SHOWN INSTALLED WITH WINCH

OPTIONAL D-RING MOUNT INSTALLATION INSTRUCTIONS #1046 ( See Above)

1. Install with the supplied hardware included with the winch

plate as instructed above. See Photo 11 for a completed

view.

Photo 10

ASSEMBLY SHOWN

1 2 3 4

Keine Kommentare

Rough-country 1062 Bedienungsanleitung Seite 3