Rough-country 388.22 Bedienungsanleitung PDF herunterladen

03-07 2500/3500 Dodge 5” Long Arm Kit

Thank you for choosing Rough Country Suspension for your Off Road needs.

Rough Country recommends a certified technician installs this system. In addition to these instructions, professional

knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to

install this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the ve-

hicle. Average professional install time for this kit is 4-6 hours.

Please read all the instructions before beginning the installation. Check the kit hardware against the kit contents list on

the last page. Be sure you have all the needed parts and understand where they go.

Product Use Information

As a general rule, the taller a vehicle is the easier it will roll. We strongly recommend, because of rollover possibility,

that the vehicle be equipped with a functional roll-bar and cage system. Seat belts and should harnesses should be

worn at all times. Avoid situations where a side rollover may occur.

Also check the steering stabilizer. It is a good idea when adding larger than stock tires to go with a larger bore steering

stabilizer or a dual unit for tires 35” and above. Inspect the stabilizer and replace as necessary.

Braking performance and capability are decreased when significantly large/heavier tires and wheels are used. Take

this into consideration while driving.

Do no add, alter, or fabricate any factory or after-market parts which increase vehicle height over the intended height

of the Rough Country product purchased. Mixing component brands, lifts, and/or combining body lift with suspension

lifts voids all warranties. Rough Country makes no claims regarding lifting devices and excludes any and all implied

claims. We will not be responsible for any product that is altered.

This suspension system was developed for 37x12.50 tire on the stock 17” x 9” or 20” wheels at 5” of lift. On an after-

market wheel you will need to purchase a 8” wide wheel with minimum of 4-5/8” of backspacing. When larger tires are

installed, speedometer recalibration is necessary. Due to ride height inconsistencies from the factory you may need to

slightly trim the front plastic valance for proper tire clearance.

This kit can also be used a 3500 single rear wheel truck. Use of this kit on a dual rear wheel pickup is not recom-

mended. Block and u-bolt combinations may vary with 3500 models.

On vehicles equipped with a two piece driveshaft & carrier bearing as on the Mega Cab, there is the potential

for take off vibration, depending on the severity this can be corrected with shimming down the carrier bearing.

Carrier bearing drop kit Part # 1110 is available from Rough Country. Also 2500/3500 trucks with factory over-

load springs the overload will have to be removed for the new block and u-bolt installation.

Notice to Dealer and Vehicle Owner

Any vehicle equipped with any Rough country product must have the “Warning to Driver” decal installed on the sun

visor or dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling

characteristics. INSTALLING DEALER—It is your responsibility to install the warning decal and to forward

these installation instructions to the vehicle owner for review and to be kept in the vehicle for its service life.

92138800

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1

03-07 2500/3500 Dodge 5” Long Arm Kit Thank you for choosing Rough Country Suspension for your Off Road needs. Rough Country recommends a certified

Seite 2

FRONT SUSPENSION INSTALLATION 1. Secure and block the rear tires of the vehicle on a level concrete or asphalt surface 2. Open the hood and remove t

Seite 3

10. The new control arms will be installed one side at a time on the vehicle. This is done to make it easier to remove the hardware from the arms and

Seite 4

17. Install lower control arm into new bracket using stock hardware. See Photo 8. NOTE new lower control arm will be install with the pocket facing o

Seite 5

31. Install the 12mm x 3” bolt through the bracket and slotted existing hole in the frame cross member. See Photo 12. The bolt should be installed fro

Seite 6

POST INSTALLATION INSTRUCTIONS Check all fasteners for proper torque. Check to ensure there is adequate clearance between all rotating, mobile, fixed

Seite 7

Kit Contents: 2-Coil Spring 1-Front Track Bar Bracket 2-Front Sway Bar Links 1-Pitman Arm (6616) 2003-2008 2-Rear Lift Block 4-Rear U-bolt 2-Front

Seite 8

Thank you for choosing Rough Country Suspension for your Off Road needs.

Kommentare zu diesen Handbüchern

Keine Kommentare

Rough-country 388.22 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Rough-country 388.22 herunter. Rough Country 388.22 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Rough-country 388.22